Hotspot Maker 3.6 instal the new for ios

How to Install Hotspot Maker 3.6 on iOS Devices: A Step-by-Step Guide

Installing the latest version of Hotspot Maker 3.6 on your iOS device can be a bit technical, but with this step-by-step guide, you'll be up and running in no time.

Before we dive into the installation process, it's essential to understand that the switch will boot in Bundle mode if you're using Hotspot Maker 3.6 for the first time. This means that your boot variable should not point to any specific location, as all packages and provisioning files used to boot in installed mode must reside on the flash.

One important thing to note is that booting in installed mode from USBFlash0: or TFTP is not supported. Instead, you'll need to use a bundle mode to install Hotspot Maker 3.6. This process is similar to installing a monolithic IOS image.

To get started, simply enter the following command on your switch: 'boot flash:cat3k_caa-universalk9.SSA.03.08.83.EMD.150-8.83.EMD.bin'. This will load the Hotspot Maker 3.6 installation package onto your device.

Once the installation is complete, you can use the 'software expand' command to convert your switch into Install mode from Bundle mode. This will allow you to install and rollback software as needed.

For those who are familiar with IOS XE, it's worth noting that installation and software rollback are only supported when the switch is running in Install mode. With these steps, you'll be able to easily install Hotspot Maker 3.6 on your iOS device and start taking advantage of its features.

By following these simple steps, you can ensure a smooth and successful installation process for Hotspot Maker 3.6 on your iOS device.

Hotspot Maker 3.6 instal the new for ios